Flow Measurement & Control

Electronic Flowmeters Code 5050A

The Conflow Code 5050A - Electronic Flowmeter gives a linear electrical signal corresponding to the volume rate of flow of fluid in the pipeline or system. The principle of operation is based on the Conflow Code 452 flowmeter.

In this case the moving magnet causes a Hall Effect Diode to produce a signal dependent on the strength of the magnetic flux around it. In this way the flow of fluid through the meter is transduced to a directly proportional electronic signal. The unit incorporates an on board LCD display showing rate, pressure and temperature.

The transducer is also compatible with a wide range of instruments, data loggers, display devices and outstations to provide remote display of fluid flow, fluid temperature and totalization of flow with respect to time.

Typical Applications

  • Monitoring water or oil flows to the various systems on coal cutting machines, AFC gearboxes and roof bolting machinery
  • Monitoring water lines for dust suppression, motor cooling, ITP systems and fire fighting


  • 1/2", 3/4",1" & 1 1/4” sizes available
  • Maximum working pressure 400 bar
  • 4 – 20mA or 0.4 – 2 V.dc flow output versions
  • Accuracy 1.5% of FSD (1%, 0-80°C)
  • Cable Gland Entries
  • I.S. Approved - Cert. ATEX 05ATEX2294, IECEX SIR05.0061 AN2Ex 06.3032x
  • Unit available with or without pressure transducer

Also Available

  • Bypass Electronic Flowmeter, Suitable for high pressure and flow rate - Details on request

The information on this data sheet is accurate to the best of Conflow’s knowledge, however we reserve the right to alter the product specification at any time. For any specific updated detail, please contact us.

Download Spec Sheet